New Ag & Industrial Parts / Leading Warranty / Fast Shipping / Low Prices / 90,000+ Parts

Parts for Case/Case IH 7140 Tractor

Air Conditioning

A/C Hose Lines/Kits

Blower/Condenser Motors


Compressor Clutches

Compressor/Compressor Kits


Electrical Parts


Evaporator Cores/Shut-Off Valve

Expansion Valves

O-rings/ Fittings/ Misc

Receiver Driers



Cab Parts


Cooling System

Draft Sensing Parts

Engine Overhaul Kits

Engine Parts

Case/Cummins 6T830 Diesel

Case/Cummins 6TA830 Diesel

Case/Cummins 6TA830 dsl.

Engine Oil Pump, Cooler, and Related

Engine Related Parts

Gaskets/Gasket Sets


Front Axle/Steering Parts

Axle Related Parts

Front Axle Components

Spindles and Related Parts

Steering Arms and Shafts

Steering Cylinders and Repair Kits

Steering Related Parts

Tie Rods and Ball Joints

Wheel Components

Fuel System

Hitch & Drawbar Parts

Hydraulic System

Ignition & Electrical Parts



PTO Components

Rear Axle/Steering Parts

Tie Rods and Ball Joints


Service Manual

Hoods, Cowls, Grilles, Panels, Screens

Transmission & Rear Axle

More about the Case/Case IH 7140

Case/Case IH started producing the 7140 Tractor in 1987 and continued until 1993. Did you find a good deal and buy the Case/Case IH 7140 Tractor for less than the original price of $91,000 (1993)? Even if you didn't, rest assured we have plenty of Case/Case IH 7140 Tractor parts in our inventory at 60% off dealer prices for your parts needs. Sometimes, the parts compatibility is determined by the serial number of your Case/Case IH 7140 Tractor, and that info should be listed on the part fit notes. If you don't have the serial number of your tractor, you can find it on the floor, inside the tractor's cab. The serial number starts from 9949001 for a 1987 model, from JJA0001501 for a 1988 model, from JJA0008528 for a 1989 model, from JJA0018838 for a 1990 model, from JJA0030160 for a 1991 model, from JJA0039300 for a 1992 model, from JJA0046350 for a 1993 model. Some Case/Case IH 7140 Tractors have a 4x2 2WD chassis, but there are also some with a 4x4 MFWD 4WD optional chassis, all equipped with hydrostatic power steering. They also have differential hydraulic wet disc brakes. The type III/IIIN 3-point hitch is very reliable. It is used with an electronic lower link. It is also worth noting that the independent rear PTO runs at 1000 (1.75) rpms. The Case/Case IH 7140 has a closed center pressure flow compensated (PFC) hydraulics system with a 50.5 gal [191.1 L] capacity. The pump does the job pushing 22 gpm [83.3 lpm] fluids in the hydraulics system.