New Ag & Industrial Parts / Leading Warranty / Fast Shipping / Low Prices / 90,000+ Parts

Parts for John Deere 2940 Tractor

Air Conditioning

A/C Hose Lines/Kits

Blower/Condenser Motors


Compressor Clutch Bearings

Compressor Clutches

Compressor/Compressor Kits


Electrical Parts


Evaporator/Temp Controls

Expansion Valves

Heater Control Valves

O-rings/ Fittings/ Misc

Receiver Driers




Cab Parts


12-5/8' Clutch - Diaphram

Prior to S/N 415943

S/N 415944 & Up

Single Clutch

Cooling System

Engine Overhaul Kits

Engine Parts

6-359 Diesel

6.359D Diesel, 300 Series

6059D Diesel, 300 Series

Crankshaft & Components

Engine Oil Pump, Cooler, and Related

Engine Related Parts

Exhaust System Parts


Gaskets/Gasket Sets



Front Axle/Steering Parts

Fuel System

Hitch & Drawbar Parts

Drawbars and Related Parts

Hitches: 2PT and 3PT

Lift Link Balls

Lift Link Components

Load Control Shafts/Components

Rockshaft Cylinders and Parts

Stabilizer and Sway Block Parts

Hydraulic System

Ignition & Electrical Parts

Mufflers/Exhaust Pipes

PTO Components

Rims & Wheels


Service Manual

Transmission & Rear Axle

More about the John Deere 2940

Production of the John Deere 2940 Tractor started in 1980 and continued until 1982. Sometimes, the parts compatibility is determined by the serial number of your John Deere 2940 Tractor, and that info should be listed on the part fit notes. If you don't have the serial number of your tractor, you can find it on the front-right of the Deere 2940 frame, above the front axle. The serial number starts from 350000 for a 1980 model, from 390496 for a 1981 model, from 418953 for a 1982 model. Some John Deere 2940 Tractors have a 4x2 2WD chassis, but there are also some with a 4x4 MFWD 4WD chassis, all equipped with power steering. They also have differential hydraulic wet disc brakes. The type II 3-point hitch is very reliable. It is used with a position control and lower-link draft sensing. It is also worth noting that the independent rear PTO runs at 540/1000 rpms.